Corghi Exact 60 Manual | 90% ESSENTIAL |

Disclaimer: This report is a compiled technical summary based on standard manufacturer documentation, service bulletins, and industry best practices. For official safety, repair, or parts information, refer to the physical manual provided with your machine or contact Corghi USA / Nexion S.p.A.

6. Calibration Procedure

If the machine provides inaccurate readings (e.g., requires weights on a wheel that is already balanced), calibration is necessary. corghi exact 60 manual

1. Enter standard dimensions for a test wheel.
2. Start a spin cycle without any wheel mounted (or with a known balanced wheel).
3. Press the calibration button (often hidden or a specific key combination like holding C while powering on).
4. Follow on-screen prompts to add a specific test weight (usually 100g) to a specific hole on the shaft.
5. Spin the machine. It will calculate new calibration offsets.

5. Operating Instructions

Routine maintenance (daily/weekly)

• Daily: Clean turntable and tools; inspect clamps and duckhead.
• Weekly: Check and top hydraulic/oil levels; lubricate pivot points.
• Monthly: Inspect hoses/fittings; check foot pedal return springs.
• Replace worn duckhead/demount inserts and clamp pads as needed.

Daily Checklist

• Wipe down the shaft and cones with a clean rag. Never use oily rags.
• Check the safety hood switch (if the machine starts with the hood open, replace the microswitch immediately).
• Clean the weight pliers.

1. Introduction & Safety

The Corghi Exact 60 is a heavy-duty, manual tire changer designed for steel and aluminum rims of trucks, buses, agricultural vehicles, and industrial machinery. Disclaimer: This report is a compiled technical summary

• Max Rim Diameter: 26 inches (handling up to 60 inches with optional track extension).
• Max Rim Width: 26 inches.
• Max Tire/Wheel Weight: 1800 kg (4000 lbs).
• Power Supply: 400V – 3 phase – 50/60 Hz (Hydraulic motor: 1.5 kW / 2 HP).
• Operating Pressure (Hydraulic): 180 bar (2600 psi).

Safety Warnings:

• Never exceed the machine’s rated capacity.
• Use only Corghi-original bead breaker shoes and clamps.
• Always wear steel-toe boots and safety gloves when operating.
• The machine must be anchored to a concrete floor using the four base bolts.