Ericsson Mini Link Cli Commands -
Ericsson Mini-Link CLI Commands — Quick Reference & Practical Guide
This guide gives a structured, practical, and engaging overview of common Ericsson Mini-Link CLI commands, grouped by task and purpose. It’s written for field engineers, network operators, and anyone who needs fast, actionable CLI help while working on Mini-Link microwave equipment.
Scenario C: Ethernet Port Flapping Investigation
MINI-LINK# show interface eth3
# Look for CRC errors, alignment errors
MINI-LINK# clear counters interface eth3
MINI-LINK# show interface eth3 statistics interval 10
# Compare against cable spec
Radio Performance Parameters
| Command Output Field | Meaning | Typical Good Value | |----------------------|---------|--------------------| | RSL (Rx Signal Level) | Received signal | -40 to -60 dBm | | XPI (Cross Polarization) | Antenna polarization isolation | >25 dB | | MUT (Minimum Unfaded Threshold) | Fade margin | >30 dB | | TX Power | Transmitted power | +15 to +25 dBm | | BER (Bit Error Rate) | Raw before FEC | < 10^-6 | ericsson mini link cli commands
2. Checking System Health
Before touching anything, check the unit's uptime and current status. This tells you if the unit has rebooted recently (indicating a power cycle or crash) and verifies the software version. Ericsson Mini-Link CLI Commands — Quick Reference &
show version
Why use it: It confirms the Serial Number and Software Release (e.g., MLTN 6.0), which is crucial for compatibility checks. Radio Performance Parameters | Command Output Field |
8. Software Management
Managing the firmware (Software Package - SP) is critical for network stability.
11. Firmware Management via CLI
MINI-LINK# show boot-image # Current & backup firmware
MINI-LINK# copy tftp://10.10.1.200/minilink-21.1.1.bin image1
MINI-LINK# boot system image1 # Set next boot to new image
MINI-LINK# reload
# After reboot, verify:
MINI-LINK# show version
5.4 Service Monitoring
admin> services status name=Backhaul_RAN
admin> services counters name=Backhaul_RAN reset