Ws-1958bt Music Car Speaker Manual Link -
Long-press the Mode button (M) or toggle the power switch, usually located on the "trunk" or bottom of the car. Bluetooth Mode:
Switch to Bluetooth mode. Open your phone's Bluetooth, search for "WS-1958BT", and pair. It supports hands-free calling.
Switch to FM mode. Short-press the Play/Pause button to search for stations. Mode Switching:
Short-press the "M" button to toggle between Bluetooth, FM radio, TF card, and USB input. Volume/Track Control:
Long-press volume buttons to change volume; short-press to skip to the next or previous track. Selfie Mode:
Some versions support Bluetooth selfie, activated via button combination. 2. Charging and Battery
Connect the USB power cable (usually included) to a 5V charging source. LED Indicator: A charge indicator light typically turns on while charging. Play Time: Approximately 2–3 hours depending on volume. Battery Capacity: Built-in 18650 battery (often 1200mAh to 1800mAh). 3. Specifications Output Power: 3 Watts (6W total) or 2 Bluetooth Version: Frequency Range: 100-18KHz. Connectivity: Bluetooth, TF Card, USB Drive, AUX (audio line-in). Horn/Driver: 2 x 52mm Drivers (External Magnetic). 4. Troubleshooting Speaker does not turn on: Charge the device for at least 2 hours. Bluetooth not connecting:
Turn the speaker off and on again, ensure no other device is connected. FM radio reception is poor: Plug in the AUX/USB cable, as it acts as an antenna.
Note: This information is based on supplier datasheets for the EONKO/WSTER WS-1958BT Car Shape Speaker. WS-1958BT - Car MODEL SPEAKER ws-1958bt music car speaker manual
The WSTER WS-1958BT is a portable Bluetooth speaker designed as a classic car model, combining vintage aesthetics with modern audio features like FM radio, USB/TF card support, and hands-free calling. Device Specifications
The WS-1958BT is built for portability and versatile playback options: Audio Output: Dual 3W stereo speakers (total 6W).
Battery: Built-in 1800mAh rechargeable 18650 battery (some variants may use 1200mAh).
Bluetooth Version: Bluetooth 5.0 (Zhongke solution) with a range of up to 10 meters. Frequency Response: 100Hz – 18KHz.
Inputs: USB port, TF (microSD) card slot, and 3.5mm AUX/headphone jack.
Special Features: LED digital screen, RGB "dazzle" lights, and a "Bluetooth selfie" (shutter) mode. Operating Instructions 1. Powering On/Off
Locate the power switch or main button (often found in the "trunk" or back of the car model).
Power On: Press and hold the M or Power button for approximately 3 seconds until you hear a startup tone or see the LED screen light up. Power Off: Press and hold the same button for 3 seconds. 2. Bluetooth Pairing AliExpress Long-press the Mode button (M) or toggle the
The is a portable car-model Bluetooth speaker produced by WSTER. It features a unique taxi car design with built-in multimedia capabilities including Bluetooth 5.0, FM radio, and TF card support. Key Specifications According to the product details from WSTER and AliExpress: Audio Output: (varies by variant).
Battery: Built-in rechargeable 18650 battery (1200mAh to 1800mAh).
Connectivity: Bluetooth 5.0, USB, TF Card (microSD), and AUX input. Extra Features: FM Radio (
), hands-free calling, and a Bluetooth "selfie" remote function. Operating Instructions
While a full PDF manual is often included in the box, here are the standard operating procedures for WSTER car speakers:
Powering On/Off: Use the power switch (often located at the rear or bottom of the car model). A voice prompt or sound usually indicates the device is on. Bluetooth Pairing:
Turn on the speaker; it defaults to Bluetooth mode (indicated by flashing lights or a sound). Enable Bluetooth on your phone and search for " " or similar.
Select the device to pair. Once connected, you can stream music or take calls. Red Wire: Connects to the vehicle’s DC 12V
Mode Selection: Use the M (Mode) button to cycle between Bluetooth, FM Radio, USB, and TF card modes. FM Radio: Switch to FM mode. Press and hold the Play/Pause button to auto-scan stations. Use the "Next/Previous" buttons to switch saved stations. Charging: Connect the included USB cable to a
power source. A charging indicator light will typically stay on until fully charged. Troubleshooting
Not Turning On: Ensure the battery is charged. If it only works while plugged in, the internal battery may be depleted.
Pairing Issues: Clear your phone's Bluetooth cache and ensure the speaker is not already connected to another nearby device. WS-1958BT - Car MODEL SPEAKER
4. Getting Started
The Wiring Loom (Back/Side)
- Red Wire: Connects to the vehicle’s DC 12V positive terminal (often the ignition switch or accessory wire).
- Black Wire: Connects to the vehicle’s Ground (negative terminal).
- (Optional on some models) Blue Wire: Usually intended for connecting an external amplifier or power antenna.
Part 2: What’s in the Box? (Unboxing Checklist)
Before reading the WS-1958BT manual, ensure your package includes all the following:
- WS-1958BT Main Speaker Unit (approx. 8–10 inches wide).
- 12V DC Car Power Cable (cigarette plug with inline fuse).
- Wired Microphone (3.5mm jack).
- Remote Control (CR2025 battery included in some batches).
- Mounting Strap or Suction Cups (for dashboard or windshield attachment).
- Quick Start Guide (the minimalist manual).
Note: If any item is missing, contact your seller. The WS-1958BT does not include an AC wall adapter—it is designed exclusively for 12V car use.
Chapter 2: Basic Controls and Interface
Your WS-1958BT has a button layout that may be confusing at first. Refer to this key:
| Button Symbol | Function (Short Press) | Function (Long Press) | | --- | --- | --- | | ⏻ (Power) | Play/Pause music | Turn unit ON/OFF | | ▶| Next track / Next FM station | Volume up | | ◀| Previous track / Previous FM station | Volume down | | MODE | Switch between BT, FM, USB, AUX, SD | – | | LED | Change light color / effect | Turn LED on/off | | Phone (☎) | Answer/End call | Redial last number |
Display Screen: Shows current mode, FM frequency, track number, or “bLUE” (Bluetooth pairing).