Skip to content
PandaSuite Docs

Coolsand Rda Usb Driver 32 Bit [2021] -

Here’s a technical write-up for the Coolsand RDA USB Driver (32-bit) , suitable for documentation, a support article, or a developer note.

Step 4: Install the Driver via Device Manager

  1. Open Device Manager (Right-click Computer > Manage > Device Manager).
  2. Look for an unknown device labeled "RDA Device", "Unknown Device", or "Coolsand USB Port" with a yellow exclamation mark.
  3. Right-click the unknown device and select Update Driver Software.
  4. Choose Browse my computer for driver software.
  5. Click Browse and navigate to the extracted folder containing rda_usb.inf or coolsand.inf.
  6. Check Include subfolders.
  7. Click Next.
  8. If prompted with a Windows Security warning about an unsigned driver, select Install this driver software anyway.

Alternatives and Modern Workarounds

If you cannot get the 32-bit driver to work, consider these options: coolsand rda usb driver 32 bit

  1. Virtual Machine: Run Windows XP 32-bit inside VMware or VirtualBox on your modern 64-bit PC. Pass the USB device through to the VM. This is the most reliable method.
  2. Legacy Hardware: Keep an old netbook or laptop with Windows 7 32-bit just for phone flashing.
  3. Hardware Boxes: Devices like the Infinity CM2 or Octopus Box have their own signed drivers that handle the Coolsand protocol via a hardware dongle, bypassing the need for the raw RDA USB driver.
  4. Linux Alternative: Some open-source tools (like android-tools-adb and usb_modeswitch) can detect RDA devices on Linux without needing signed drivers.

Issue 2: Device not detected

  • Cause: Bad USB cable or port.
  • Solution: Use a high-quality USB cable. Avoid USB hubs; plug directly into the motherboard's USB port.

Step 2: Connect the Device (The "F8" Dance)

Hold the specific key combination on your phone/device to enter Flash Mode or Download Mode. Here’s a technical write-up for the Coolsand RDA

  • Common combo: Volume Down + Power, or pressing "Download" on the dev board.
  • Connect the USB cable. You will see an unknown device in Device Manager under "Other devices" (likely with a yellow triangle).

4. Installation Steps (32-bit Windows)

  1. Disable driver signature enforcement (for Windows 7–8.1 32-bit) – not required for XP.
  2. Connect the device in download mode:
    • Turn phone off → hold specific key (e.g., Volume Down or '*' ) → insert USB cable.
    • Device appears as “Unknown” or “RDA USB Port” in Device Manager.
  3. Install manually:
    • Open Device Manager → right-click unknown device → Update driver.
    • Select “Browse my computer for drivers” → point to extracted driver folder.
    • Choose “Let me pick from a list…” → Have Disk → select coolusb.inf.
  4. Confirm installation if warning appears (unsigned driver – safe for 32-bit dev use).
  5. After success, a new COM port appears under Ports (COM & LPT) , e.g., “Coolsand RDA USB Serial Port (COM3)”.

2. What is the Coolsand RDA USB Driver?

The Coolsand RDA USB Driver is a software package that acts as a bridge between the Windows Operating System and a mobile device running on a Coolsand/RDA chipset. Step 4: Install the Driver via Device Manager

Without this driver, when you connect a Coolsand device to a PC, Windows will often fail to recognize it, labeling it as an "Unknown Device" or failing to assign a COM port. This driver creates a Virtual COM Port (VCP), allowing service software (like flashing tools) to communicate with the phone's internal processor.